adhesive friction
英
美
[网络] 黏著摩擦
双语例句
- The results show that the plow effect between friction pairs and adhesive area of friction surface could be effectively reduced with incorporation of SiC particles, which decrease the mass-loss wear of composite plating layer.
结果表明：SiC颗粒的加入能有效地降低摩擦副之间的犁沟效应及摩擦表面发生粘着的面积，从而减少镀层的磨损。 - The mechanism shows hysteresis friction at low load while adhesive friction at high load.
在较低载荷时，丁腈橡胶表现为滞后摩擦，在较高载荷时，表现为粘着摩擦； - Results show that for certain fractal dimension, the total adhesive friction coefficient reduces sharply as the normalized contact area increases.
结果表明，对于一定的分形维数，总的粘着摩擦系数随归一接触面积的增大而急剧减小。 - Near the latter point, the strain velocity of adhesive friction and that of slide friction is near to be equal and friction coefficient has almost no effect to the strain velocity with slide friction.
在轧件与轧辊分离处，变形速度为零，在这点附近粘着摩擦和滑动摩擦变形速度值接近相等，摩擦系数几乎不影响滑动摩擦情况下的变形速度。 - We also find that, due to the water vapor condensation, the adhesive force and friction coefficient on sample surfaces increase first, then decrease with the relative humidity increase.
由于强的亲水性，样品表面的摩擦系数和黏附力随着湿度的增大先逐渐增大，然后急剧减小。 - The results also indicated that it is the adhesive component of frictional force that let the friction vibration to be intensified.
真空中摩擦力的粘着分量是使摩擦振动加剧的主要原因； - This paper sets up a mathematical model for calculating thermal balance of plunger-cylinder wall friction pair in axial plunger pump, analyzes the cause of producing adhesive wear on the friction pair, and puts forward a way to solve the problem.
本文提出了轴向柱塞泵柱塞&缸孔摩擦副热平衡计算的数学模型，进而分析了这对摩擦副产生粘着磨损的原因，并提出了解决办法。 - In the process of emergent brake, relations among brake press, parameters of the entire vehicle and adhesive coefficient between tire and road surface influence the distribution of brake disc friction temperature field greatly.
在紧急制动过程中，制动压力、整车参数以及轮胎与路面间附着系数之间的关系对制动器摩擦温度场分布有重要的影响。 - The total adhesive friction coefficient is expressed as a combination of adhesive friction coefficients in elastic and plastic contact regime.
总的粘着摩擦系数被表示为弹性接触区与塑性接触区的粘着摩擦系数的组合。 - It provides theoretical foundation for determining the size of pressing load. Finally, a fractal model of adhesive friction coefficient is proposed by comparing the normal elastic load with the normal plastic load acting on particle contact points.
最后，通过比较作用于颗粒接触点的法向弹塑性载荷，提出了粘着摩擦系数的分形模型。